Common questions and answers.
How do I replace a magnet in my copper band?
Clean area hole where magnet was with Acetone & a cotton bud and possibly a circular file to remove all glue particles. Order the required magnets from here..
https://sacred-nz.co.nz/products/super-strong-neodymium-rectangle-magnets-5x1-grade-n45-rare-earth-round-magnets?utm_source=copyToPasteBoard&utm_medium=product-links&utm_content=web
Using a two pot Araldite glue either supper strength or 5 minute and place magnet and covered cap we have already placed on your purchased magnet with the silver open back of the magnet facing in the hole so that the cap in brace protects your magnet from water damage. We would have already placed your magnet in the cap with the polarity correctly facing the right way for positive benefits
How do I remove my copper band?
Please view video below
I wish to sell your products in my store do you sell wholesale.
Yes we do, please contact us with your store name address, email, phone number and we will set up a wholesale account for you with a discount code. Sacrednewzealand@yahoo.co.nz
I ordered my bracelet size too big how to resolve.
All our clasps are stainless steel and heat will not damage them..the same for our bands they are real leather and heat will not burn leather..so undo your clasp, place this end in the stainless steel part on a bare flame (like gas element) for 30 seconds or so. Using a cloth so as not to burn your fingers pull the clasp away from the leather as the glue will compromise and loosen. Then simply cut off the excess leather and allow for enough leather to return inside the clasp you can check the size before you re glue. Now use a two pot mix aladite glue. 5min is ok or 24hr super strength araldite are best.
If you purchased a wire strung leather bracelet these will spring open when cut and need to be cut with metal cutters, ensure you tape tightly the section just behind the cut, you will need to push these into the clasp with a sharp fine tool or return to us to alter P.O box 433, Nelson city 7010.
My copper bracelet has gone silver, why has this happened and is it real copper.
Firstly yes, all our items are real 100% copper, not plated.
In some situations where an individual has been compromised by heavy metals found in mercury fillings, water, anaesthetic, dental pain killer injections, being a metal worker, flu injections which have graphene, Covid injections which have graphene, antibiotics encased in gel caps made with graphene. Medications printed with graphene, food sprayed with toxins. These all can cause accumulation of metals in the human body creating health issues.
So when wearing a copper magnetic band the heavy metals can then be drawn from the body and start to accumulate on the copper bracelet, infusing it with a silver electroplating made from your body. This is one of the truely wonderful benefits of wearing magnetic 100% copper.
Your band needs to be cleaned regularly back to your copper base and should decrease with time as the metals are drawn from the body, unless you continue to receive more toxic injections and contact with heavy metals.
How do I clean my copper band.
There are many ways to clean copper and is similar to silver cleaning and stainless steel. So if you have any kitchen appliance cleaning products you can use these. Other suggestions are Coca Cola leave to soak overnight. Cemco cleaning pink paste with a cloth. Soft wet and dry sand paper. Copper cleaning pastes and cloths.
Salt, vinegar and flour combine to polish copper.
- Mix together one-quarter cup salt and one-quarter cup flour, then add enough vinegar to make a thick paste.
- Rub that paste on the copper surface and gently buff it using a microfiber cloth until it shines; wash and dry thoroughly.
My linked copper catch has become loose how do I tighten it?
Your copper linked band can loosen with general knocks and daily wear. This is easily resolved by tightening up the connection of your closure. Please view this YouTube video for instructions..
https://youtu.be/N-GXBBYbAIE
